©
200324 4-1
Removal and installation
PE ENGINE FUEL SYSTEM
CF65/75/85 series
4
5
4. REMOVAL AND INSTALLATION
4.1 REMOVAL AND INSTALLATION, FUEL INJECTION PIPE
Removing the fuel injection pipe
}
Always leave the injection pipes
fixed together as a complete set.
Never remove or shift the clamping
brackets (A) holding the pipes
together. Never bend injector pipes
as they may crack.
1. Disconnect the earth lead from the battery
terminal.
2. Clean the union nuts and the area around
both the injectors and the pump housing.
}
When slackening the injection pipe
union nuts, hold the injector's side
connection back using an open-end
spanner. If this is not done, there is a
good chance that the side
connection will leak.
Immediately plug the openings.
3. Remove the fuel injection pipes as a set.
i 400199
A
A
A
i 400237
https://www.truck-manuals.net/
To Next Page
Loading...
Need help?
General
