PE ENGINE FUEL SYSTEM
4-2
©
200324
Removal and installation
5
CF65/75/85 series
4
Installing the fuel injection pipe
1. Blow the injector pipes with dry
compressed air.
Then turn the injector side towards the
injectors.
2. Position the set of injector pipes with the
head on the connection of the pump unit (see
diagram).
3. Tighten the union nuts to the pump
connection by hand in the order 1-2-3
or 4-5-6.
4. Then tighten the union nuts on the injector
side by hand in the order 1-2-3 or 4-5-6.
5. Then tighten the union nuts on the pump side
in the order 1-2-3-4-5-6. Tighten them to the
specified torque. See "Technical data".
6. Now tighten the union nuts on the injector
side in the order 1-2-3-4-5-6.
}
When tightening the injector pipe
union nuts, hold the injector's side
connection back using an open-end
spanner. If this is not done, there is a
good chance that the side
connection will leak.
7. Tighten the injector pipe union nuts to the
specified tightening torque. See "Technical
data".
i400506
i 400237
https://www.truck-manuals.net/
To Next Page
Loading...
Need help?
General
