PE ENGINE FUEL SYSTEM
4-4
©
200324
Removal and installation
5
CF65/75/85 series
4
Installing the injector
1. Clean the injector sleeve. See "Cleaning".
2. Fit a new O-ring (1) and a new copper shim
(2) to the injector. Apply a little acid-free
grease to both rings.
3. Inspect the valve sleeve seal (3) of the
injector. Replace it if it is leaking and/or
damaged.
Note:
Make sure that the injector clamp is installed
correctly.
4. Fit the injector together with the injector
clamp (4) and tighten the attachment bolt to
the specified torque. See "Technical data".
5. Fit the DEB.
6. Adjust the DEB clearance.
i 400183
3
4
1
2
https://www.truck-manuals.net/
To Next Page
Loading...
Need help?
General
