TECHNICAL DATA
5-2
©
200416
PE engine inlet/exhaust system
0
ΧΦ65/75/85 series
4
5.2 TIGHTENING TORQUES
The tightening torques specified in this section
are different from the standard tightening torques
cited in the overview of the standard tightening
torques. The other threaded connections not
specified must therefore be tightened to the
torque cited in the overview of standard
tightening torques.
When attachment bolts and nuts are replaced, it
is important that - unless stated otherwise - these
bolts and nuts are of exactly the same length and
property class as those removed.
Turbocharger
(1) Use Loctite 243 to secure
(2) Fasten with Copaslip
Glow element
Air cooler
Heat shield attachment bolts 30 Nm
(1)
Turbine housing clamp plate attachment nut 15 Nm
Exhaust manifold flange/turbocharger attach-
ment nuts 60 Nm
(2)
Elbow attachment with exhaust brake on turbo-
charger 40 Nm
Oil supply pipe banjo bolt 90 Nm
Attachment bolts 30 Nm
Air cooler hose clamps 10 Nm
https://www.truck-manuals.net/
To Next Page
Loading...
Need help?
General
