©
200324 5-3
Disassembly and assembly
PE ENGINE FUEL SYSTEM
CF65/75/85 series
4
5
1. Use the special tools (DAF no. 1329444)
and (DAF no. 0535626) to fit the bearing
shells.
Note:
Before fitting the pump camshaft, oil the
bearing journals lightly with lubricating oil.
When fitting the bearing shells, take care not
to damage them.
2. Fit the pump camshaft by lowering it
vertically into the pump housing.
3. Clean the gaskets if necessary. Fit the
gaskets and sealing plates and tighten the
bolts to the specified torque. See "Technical
data".
Note:
When fitting the locking plate, make sure it
does not stick in the pump camshaft groove.
4. Fit the locking plate of the pump camshaft
and the bolts, tightening them to the
specified torque. See "Technical data".
5. Fit the pulse disc and tighten the bolts to the
specified torque. See "Technical data".
6. If necessary, clean the groove in which the
O-ring is fitted and apply a thin layer of
lubricating oil.
7. Fit the O-ring.
i400378
https://www.truck-manuals.net/
To Next Page
Loading...
Need help?
General
