User's Manual
109
Manual add
Configure the settings for the manual adding device parameters.
Table 5-30 Manual add parameters
Channel
In the
list, select the channel that you want use on the Device to
connect the remote device.
Manufacturer In the
list, select the manufacturer of the remote device.
IP Address
In the IP Address box, enter the IP address of remote device.
The default is 192.168.0.0 which the system cannot connect to.
RTSP Port
The default value setting is 554. You can enter the value according to your
actual situation.
HTTP Port
The default value setting is 80. You can enter the value according to your
actual situation.
If you enter other value, for example, 70, and then you should enter 70
after the IP address when logging in the Device by browser.
User Name Enter the user name of the remote device.
Password Enter the password of the user for the remote device
Remote Channel
Enter the remote channel number of the remote device that you want to
add.
Decoder Buffer In the Decoder Buffer list, select Default, Realtime, or Fluent.
Protocol Type Select
,
,
, or
. The default is
.
Click Apply to save the settings.
Only one device can be added manually at one time.
indicates successful connection and indicates connection failed.
To Next Page
Loading...
Need help?
General
