User's Manual
163
Send Email
Select the
check box to enable the system to send an email
notification when an alarm event occurs.
To use this function, make sure the email function is enabled in
Main
Menu > NETWORK > EMAIL
.
Buzzer Select the check box to activate a buzzer noise at the Device.
Log Select the check box to enable the Device to record a local alarm log.
Voice Prompts
Select to enable audio broadcast/voice prompts in response to a HDD
alarm event.
Click Apply to complete the settings.
5.10.4.2 Configuring Network Event Settings
Select Main Menu > ALARM > ABNORMITY > Network.
Network
Configure the settings for the Network event. See Step 3.
Table 5-45 Event parameters
Event Type
In the Event Type list, select Net Disconnection, IP Conflicted, or MAC
Conflicted as the event type.
Enable Enable or disable the Network event detection function.
To Next Page
Loading...
Need help?
General
