Dahua Technology VTH5421E Series - Alarm Setting

58
Figure 3-28 Card management
Procedure
Step 1 Click
Issue Card
.
Step 2 Swipe the card on the corresponding VTO.
Step 3 The card information will be added to the VTH. Assign unlock permission by selecting
Lock
1
and
Lock 2
as needed.
Step 4 Click
Confirm
.
Click
Delete
to delete the card information.
3.6.3 Alarm Setting
Set wire zone, wireless zone and alarm output.
Zones can be set under disarm mode.
3.6.3.1 Wired Zone
Background Information
Set zone type, NO/NC, alarm status and delay. It supports to set 8 zones at most.
Procedure
Step 1 Tap
Setting
.
Step 2 Select
Alarm
>
Wired Zone
.