Quick Configuration 14
Manual add (ONVIF) Figure 3-9
Set the parameters. See Table 3-4. Step 3
Table 3-4 Manual add parameter description
Select protocol type. It supports Private and Onvif at present.
With ONVIF protocol, PTZ control only supports rotation and zoom
function in the fixed speed mode, rather than other auxiliary PTZ
functions.
Enter start IP and end IP when one IP segment is added.
Enter start IP when one IP is added.
Enter port number. It is usually default value.
Enter username and password.
Enter channel quantity. means that it is enabled, while
means that it is disabled.
For example, total channel quantity of the device is 48.
When it is enabled, you can set the channel quantity to display
1
st
channel –16
th
channel.
When it is disabled, display the total acquired channels.
It is supported by Onvif protocol only.
When it is encrypted, port number is 443 by default.
When it is not encrypted, port number is 80 by default.
Cameras shall enable HTTPS function.
Click . Step 4
To Next Page
Loading...
Need help?
General
