Local Configurations 85
Adjust the sharpness of image edge. The bigger the value is, the
more obvious the image edge, and the noise is also greater.
The value ranges from 1 to 15. The default value is 1.
Adjust the hue of image. The value ranges from 0 to 100. The
default value is 50.
Adjust the image brightness. The value ranges from 0 to 100. The
default value is 50.
The bigger the value is, the brighter the image will become. You
can adjust this value when the image as a whole looks dark or
bright. However, the image is likely to become dim if the value is
too big.
The recommended range is between 40 and 60.
Adjust the image contrast. The bigger the value is, the more
obvious the contrast between the light area and dark area will
become. You can adjust this value when the contrast is not
obvious. However, if the value is too big, the dark area is likely to
become darker and the light area over exposed. If the value is too
small, the image is likely to become dim.
The value ranges from 0 to 100. The default value is 50. The
recommended range is between 40 and 60.
Adjust the color shades. The bigger the value, the lighter the color
will become. This value does not influence the general image
lightness.
The value ranges from 0 to 100. The default value is 50. The
recommended range is between 40 and 60.
In the Color Mode list, you can select Standard, Soft, Bright,
Colorful, Bank, Customized 1, Customized 2, Customized 3,
and Customized 4.
The sharpness, hue, brightness, contrast and saturation will adjust
automatically according to the selected color mode.
Enhance the image effect. Adjust the effect value.
Click , image is adjusted to the optimized effect
automatically.
Click , the current effect setting will be locked.
Only HD analog channel supports this function.
Adjust the display position of the image in the channel window. The
value indicates pixel. The default value is 16.
This function is only supported by analog channel.
To Next Page
Loading...
Need help?
General