Local Configurations 57
5.1.3.3 Using Reset Button on the Mainboard
You can always use the reset button on the mainboard to reset the Device to the factory default.
Not all models are provided with reset button.
Disconnect the Device from power source, and then remove the cover panel. For Step 1
details about removing the cover panel, see "2.2 Installing HDD."
Find the reset button on the mainboard, and then press and hold the reset button for 5 Step 2
seconds to 10 seconds. See Figure 5-17 for the location of the reset button.
Figure 5-17
Reboot the Device. Step 3
After the Device is rebooted, the settings have been restored to the factory default. You
can start resetting the password.
5.1.4 Setting Up with the Startup Wizard
5.1.4.1 Entering Startup Wizard
The Startup Wizard helps you configure the basic settings to set up the Device.
After you have initialized the Device, the Startup Wizard interface is displayed. See Figure
5-18.
To Next Page
Loading...
Need help?
General