Local Configurations 177
In the Event Type list, select Network Security Exception, including
brute force attack of Web path, brute force attack of session ID,
session connection over-limit and abnormal program in trusted
environment.
Not all models support this function.
Click the switch behind Enable. means that it is enabled.
Click Setting to set alarm output port. Enable alarm activation
through the alarm devices connected to the selected output port when
an alarm occurs.
Set a length of time for the Device to delay turning off alarm after the
external alarm is cancelled. The value ranges from 10 seconds to 300
seconds, and the default value is 10 seconds.
There is no delay when the latch is 0.
Select the check box to activate a buzzer noise at the Device.
Select the check box to enable the Device to record a network
exception log.
Select the Send Email check box to enable the system to send an
email notification when an alarm event occurs.
To use this function, make sure the email function is enabled in Main
Menu > NETWORK > EMAIL.
Select to enable audio broadcast/voice prompts in response to a user
account alarm event.
Table 5-44
Click Apply to complete the settings. Step 3
5.11 Smart Detection
Smart detection includes SMD, human face and IVS.
The system processes and analyzes video images, abstracts key information from the video,
and activates alarms when it detects that person, vehicle, face or behavior matches the
detection rule.
Not all models support this function.
Only the analog channel 1 supports this function. The IP channel does not support this
function.
SMD, face detection function, and IVS function cannot be enabled at the same time.
To Next Page
Loading...
Need help?
General