Local Configurations 215
Show Message: Select the Show Message check box to enable a
pop-up message in your local host PC.
Buzzer: Select the check box to activate a buzzer noise at the
Device.
Video Matrix: Select the check box to enable the function. When
an alarm event occurs, the video output port outputs the settings
configured in "Main Menu > DISPLAY > TOUR."
Not all models support this function.
Send Email: Enable the system to send an email notification when
an alarm event occurs.
To use this function, make sure the email function is enabled in Main
Menu > NETWORK > EMAIL.
Log: Select the check box to enable the Device to record a local
Select the check box to enable the function. When an alarm event
occurs, the extra screen outputs the settings configured in Main
Menu > DISPLAY > TOUR > Extra Screen.
Not all models support this function.
To use this function, extra screen shall be enabled.
Table 5-52
Click OK to save the settings. Step 5
On the Wireless Detector interface, click Apply to complete the settings. Step 6
5.12.2 Configuring Temperature and Humidity Camera
You can view, search and export the temperature and humidity data of camera with such
sensors and configure the alarm event settings.
To use this function, please make sure there is at least one camera with temperature and
humidity sensor has been connected to the Device.
5.12.2.1 Enabling Detecting Function
You should enable the IoT function the first time when you enter this interface.
On the main menu, select IoT > MANAGER > Temperature/Humidity. Step 1
The Temperature/Humidity interface is displayed. See Figure 5-181.
To Next Page
Loading...
Need help?
General