Local Configurations 214
Configure the settings for alarm linkage. For details, see Table 5-52. Step 4
Enter the customized alarm name.
Click Setting to display setting interface.
Define a period during which the motion detection is active. For details,
see "Setting Motion Detection Period" section in "5.10.4.1 Configuring
Motion Detect Settings."
Click Setting to display the PTZ interface.
Enable PTZ linkage actions, such as selecting the preset that you want
to be called when an alarm event occurs.
Click Setting to display setting interface.
General Alarm: Enable alarm activation through the alarm devices
connected to the selected output port.
External Alarm: Enable alarm activation through the connected
alarm box.
Wireless Siren: Enable alarm activation through devices
connected by USB gateway or camera gateway.
Set a length of time for the Device to delay turning off alarm after the
external alarm is cancelled. The value ranges from 0 seconds to 300
seconds, and the default value is 10 seconds.
Set a length of time for the Device to delay turning off recording after
the alarm is cancelled. The value ranges from 10 seconds to 300
seconds, and the default value is 10 seconds.
Configure the time period from end of event detection to the stop of
alarm.
Select the channel(s) that you want to record. The selected channel(s)
starts recording after an alarm event occurs.
The recording for alarm and auto recording must be enabled. For
details, see "5.1.4.9 Configuring Recorded Video Storage Schedule"
and "5.9.1 Enabling Record Control."
Select the Snapshot check box to take a snapshot of the selected
channel.
To use this function, select Main Menu > CAMERA > ENCODE >
Snapshot, in the Mode list, select Event.
Select the Tour check box to enable a tour of the selected channels.
Select to enable audio broadcast/voice prompts in response to a local
alarm event.
To Next Page
Loading...
Need help?
General