Local Configurations 153
Figure 5-117
Configure the settings for the local alarms. See Table 5-35. Step 2
Select the channel number.
Enter the customized alarm name.
Enable or disable the local alarm function.
In the Type list, select NO or select NC as the voltage output type.
Click Setting to display setting interface.
Define a period during which the motion detection is active. For details,
see "Setting Motion Detection Period" section in "5.10.4.1 Configuring
Motion Detect Settings."
Configure the time period from end of event detection to the stop of
alarm.
Click Setting to display setting interface.
General Alarm: Enable alarm activation through the alarm devices
connected to the selected output port.
External Alarm: Enable alarm activation through the connected
alarm box.
Wireless Siren: Enable alarm activation through devices
connected by USB gateway or camera gateway.
Set a length of time for the Device to delay turning off alarm after the
external alarm is cancelled. The value ranges from 0 seconds to 300
seconds, and the default value is 10 seconds.
Select the Show Message check box to enable a pop-up message in
your local host PC.
To Next Page
Loading...
Need help?
General