User’s Manual
45
Table 4-20 Barrier control parameter description
KEEP Open
Select it and enable the function of barrier normally on. Configure the period
of barrier normally on. The barrier will not close during the defined period.
Select it to enable barrier control and configuration.
Control Type
It can trigger alarm through different barrier modes.
Whitelist Open (Camera): Capture the vehicle which conforms to the allow
list or fuzzy matching and then output open barrier signal.
Every Trigger (Camera): Capture any vehicle and output open barrier
signal.
Every Plate (Camera): Capture any plated vehicle and output open barrier
signal.
Order (Server): Platform issues command and output open barrier signal.
Server IP
After enabling open barrier command and configuring IP, if the device is
offline, barrier will be opened by white list function automatically.
Click the button and manually trigger outputting signal of opening barrier.
Click the button and manually trigger outputting signal of closing barrier.
Open Config
Relay-out: Activate alarm linkage output port. You can select anyone one of
the three ports.
Signal Duration: It is the time for which the open barrier or close barrier
Close Config
Step 3 Click Confirm.
4.5.1.7 Intelligence Default
This section provides guidance on restoring capture settings and intelligent parameters to
default settings.
Step 1 Select Setup > ITC > Intelligent Default.
Figure 4-48 Intelligence default
Step 2 Click Default.
To Next Page
Loading...
Need help?
General
