User’s Manual
63
Signal Duration
The alarm linkage keeps running for the defined time after alarm ends.
The time range is 10s–300s.
Capacity Limit Configure the storage available that triggers abnormality alarm.
Ethernet Card2
Select the Ethernet card that triggers alarm output.
Max Switch Time
Value
Configure the max time that traffic light remains unchanged.
This function is only available in E-Police mode.
Login Error Configure the number of login error allowed. The range is 3–10 times.
Send Email
The system sends an email to the defined email address when an alarm
is triggered. To set the email address, go to Setup > Network >
Step 3 Click Confirm.
4.5.5 Storage
This section provides guidance on setting associated information of storage and record control.
4.5.5.1 Point
Set the storage path of snapshot.
Step 1 Select Setup > Storage > Destination > Point.
Figure 4-73 Point
Step 2 Select Event Type as needed.
Local: Store into the TF card.
FTP: Store into the FTP server.
Step 3 Click Confirm.
4.5.5.2 Local
Display the information of local SD card. You can set hot swap and format SD card.
To Next Page
Loading...
Need help?
General
