User’s Manual
69
Figure 4-79 Date & time
Step 2 Configure the parameters.
Table 4-37 Date & time parameter description
Date Format Select date format.
Time Format Select 24h or 12h system.
Time
Set current system time of the Camera. It becomes valid immediately after
setting.
Sync PC Sync the time of the Camera with the time on PC.
DST
Enable the function, and then set begin time and end time of DST. Set
according to date or week.
NTP Setting Select to enable the function of network time synchronization.
Server Time server address.
Port Port number of time server.
Time Zone The time zone where the Camera is located.
Interval The sync interval between device and time server.
Step 3 Click Confirm.
To Next Page
Loading...
Need help?
General
