Local Basic Operations 53
Figure 4-23
2) Tap on the top right corner.
The interface requiring device initialization is displayed. A pop-up message
reminding you to make sure the Device is initialized is displayed.
3) Tap OK.
If the Device has not been initialized, Tap Device Initialization to perform
initializing by following the onscreen instructions.
If the Device has been initialized, you can start adding it directly.
4) Tap Add Device.
The Add Device interface is displayed. See Figure 4-24.
You can add wireless device or wired device. The Manual takes adding wired
device as an example.
Figure 4-24
To Next Page
Loading...
Need help?
General