38 Installation Manual 3P581074-2D
DGE601A52
English
Peel away the sheath and coating of the power wire to match the dimensions shown
below. You can also refer to a [strip gauge] on the terminal block cover for the coating
peeling allowance.
<Power wire (sheath, coating)> <Terminal block cover>
10 mm
10 mm
L: 45 mm
E: 40 mm
N: 50 mm
Round crimp-type
terminal (2-M4)
* Use the included round crimp-type
terminal (2-M4) for the end of the
earth wire only (eld supply possible)
When peeling, be careful not to scratch the nish of the exposed part of the cable.
Bad example
Frayed
Too short
Bent
Too long
10 mm
Good example
(3) While engaging the tab in the area marked with a triangle, attach the terminal
block cover and secure it with the screw.
01_EN_3P581074-2D.indd 38 2021/06/25 14:12:12
To Next Page
Loading...
