ESIE98–06A Troubleshooting
Part 3 – Troubleshooting 3–27
33
4
5
1
To exit the factory
menu
When you have changed all parameters, proceed as follows to exit:
FC triac pulse length factory 2 0
A2 antifreeze-alarm hysteresis factory 5 5
A3 bypass-time for antifreeze-alarm factory 0 0
A5 antifreeze-heater differential factory 1 3
A6 supporting heaters probe factory 0 0
A7 limit antifreeze-alarm set factory - 40 - 15
P1 flow start timer factory 20 20
P2 flow stop timer factory 5 5
P3 LP bypass timer factory 40 60
P4 buzzer on time user 1 1
P5 reset of alarms factory 0 0
P8 selection of digital input ID1 factory 0 1
PA low pressure alarm when the compressor is
OFF
factory 0 0
Pb high temperature alarm set user 90 90
PC high temperature alarm delayed at start-up user 30 30
H5 pump functional logic factory 1 1
H6 cooling/heating input user 0 0
H7 on/off input user 0 0
H8 number of terminals factory 0 0
H9 keyboard lock-up user 1 1
HA serial address user 1 1
Hb infrared remote control password user 0 1
HC second set of parameters factory 0 1
Hd logic inversion cooling/heating factory 0 1
HE inversion valve status cooling/heating factory 0 1
HF alarm relay state without alarm factory 1 0
HG software release version factory 1.3 1.3
FC triac pulse length factory 2 0
A7 limit antifreeze alarm set factory -40 -15
Name Function Parameter
CAREL
(default)
EUWA/Y5-10HB
Step Action
1
Press p.
2 Put off the power supply.
To Next Page
Loading...