Installation and User Guide DEVIreg™ Multi
FEC | Produced by Danfoss © 23
Parameters setting for PR mode can be done by the following menu sequence:
EN: Main Screen – Enter to Main Menu – Channels settings – Channel #X – On Time
& Period – { Enter – #X Set On Time – Down – #X Set PR Period }
EN: Main Screen – Enter to Main Menu – Channels settings – Channel #X – On Time
& Period – { Enter – #X Set On Time – Down – #X Set PR Period }
Line of the Main screen with PR mode data for one Channel is shown on the picture below:
Time from
the beginning
of the Period (min.)
Heating status:
On or Of
On Time
(min.)
Period
(min.)
4.4.5 MOn and MOf – Manually heating On and Manually heating Of mode
Manually On/Of mode (on the screen – MOn or MOf) is control with setting time period
during which heating will be turned on or turned off. This mode can be started only on
the base of 1S or PR mode and after Manually On/Of mode is finished, controller returns
to the same initial mode – 1S or PR.
This mode can be individually set up for any Channel.
Three control parameters can be set up: time period, heating state – On or Of, and Start
or Stop mode state.
Time Period. Setting Period of time for MOn or MOf mode. Default – 1 min.
Heating status. Setting state Heating On or Heating Of. Default – Of.
Start or Stop. Starting or Stopping control mode. After finishing of MOn or MOf mode
controller goes to Stop state automatically and disappears from the screen automatically
too. Default – Stop.
NB: It is the full responsibility of the installer/user to use this mode and to set up correct states that
correspond to the specific application to avoid overheating of the cable, building materials and so on.
To Next Page
Loading...
Need help?
General
