Danfoss DEVIreg Multi

Installation and User Guide DEVIreg™ Multi
FEC | Produced by Danfoss © 31
4.4.11 Relay Counters view and reset
DEVIreg™ Multi controller is collecting information about number of times the Channel
relay is turned on.
Relay counters information can be found in two ways.
The simplest way to see ‘Relay On cycles’ in total can be done by sequence:
EN: Main Screen – Up.
EN: Main Screen – Up.
For example, the screen view can be as below:
The second way to see list of service information can be done by the following menu
sequence:
EN: Main Screen – Enter to Main Menu – Channels data – Channels data #X –
{ Down – Down }.
EN: Main Screen – Enter to Main Menu – Channels data – Channels data #X – { Down
– Down }.
For example: