Danfoss FC 300 Profibus User Manual

FC 300 Profibus
Parameters
8-55 Set-up Select
Option:
Digital input [0]
Bus [1]
Logic AND [2]
*
Logic OR [3]
Function:
Choose between controlling the drive via the
terminals (digital input) an d/or via the bus.
If you select Bus, you can only activate Selection
of Setup if it is transmitted via the serial
communication port or fieldbus option. If you select
Logic AND, you must also activate the command via
one of the digital inputs. If you select Logic OR,
you can also activate the Set-up command via one
of the digital inputs.
NB!:
This parameter is active only when par.
8-01 Control Site is set to [0] Digital and
control word.
8-56 Preset Reference Select
Option:
Digital input [0]
Bus [1]
Logic AND [2]
*
Logic OR [3]
Function:
Choose between controlling the drive via the
terminals (digital input) an d/or via the bus.
If you select Bus, you can only activate the Preset
Reference command if it is transmitted via the serial
communication port or fieldbus option. If you select
Logic AND, you must also activate the command via
one of the digital inputs. If you select Logic OR,you
can also activate the Preset Reference command via
one of the digital inputs.
NB!:
This parameter is active only when par.
8-01 Control Site is set to [0] Digital and
control word.
8-90 Bu s Jog 1 Speed
Range:
0. - par. 4-13 RPM
*
100. RPM
Function:
Sets a fixed speed (jog) activ
ated via the serial port
or bus option.
8-91 Bu s Jog 2 Speed
Range:
0. - par. 4-13 RPM
*
200. RPM
Function:
Sets a fixed speed (jog) is activated via the serial
port or bus option
60
MG.33.C2.02 - VLT is a registered Danfoss trademark

Danfoss FC 300 Profibus Specifications

General

Brand	Danfoss
Model	FC 300 Profibus
Category	DC Drives
Language	English