Danfoss Heating
13
GB
Fig. 12
c) When all events are correct, press DAY to programme events for
the next day. (If a day’s event times and temperatures are to be
repeated in another day of the week then the COPY function can
be used - see below).
d) Repeat steps b and c to programme
(or COPY) events for the rest of the
week.
To return to RUN mode, press and
release the PROG button. The display
will change to show the current
time, set temperature and actual
temperature (Fig. 12).
Normal Copy Function
1. At step d press the COPY button and the previous day’s events
will be copied into the currently displayed day.
Advanced Copy Function
1. When all 6 events are correct, press the COPY button.
2. Press the DAY button to select which day to copy to.
3. When day is selected press the COPY button.
4. Continue steps 2 and 3 until all the days you would like to copy to
have been copied.
5. To exit advanced copy mode press the DAY button until the day
copied from is selected and press the COPY button.
Note: Advanced Copy can only be used if the Advanced Copy
Function has been enabled in option 2 in User Advanced
Programming (see page 23).
To Next Page
Loading...
