Danfoss TP7001 - Page 17

Danfoss Heating
17
GB
c) Use the Λ or V buttons to adjust the required TEMPERATURE in
0.5°C (1°F) steps.
d) Press the NEXT button to move to the next preset time and
temperature (Event 2) (Fig. 23).
e) Repeat steps b, c, and d to programme the remaining events.
Programming “B” days and events
a) Press and hold the DAY button until the  rst preset time and
temperature (Event 1 for Programme B) appears in display (Fig.
24).
b) Use the + or - buttons to adjust the TIME (press and hold to
change in 10 minute increments).
c) Use the Λ or V buttons to adjust the required TEMPERATURE.
d) Press the PROG button to move to the next preset time and
temperature (Event 2) (Fig. 25).
e) Repeat steps b, c, and d to programme the remaining events.
Running the programme
Press the PROG button to return to previous RUN mode. The
heating will now follow the times and temperatures programmed
(Fig. 26).
Fig. 23
Fig. 24 Fig. 25 Fig. 26