5.2.1
5.3
5.4
5.4.1
5.4.2
5.4.3
5.5
5.5.1
6
6.1
6.1.1
6.1.2
6.2
6.2.1
6.2.2
6.3
6.3.1
6.3.2
6.4
6.4.1
6.4.2
6.4.3
7
7.1
7.2
7.3
7.4
7.5
7.6
7.7
Jumpers in the OPTC3/C5 Option Board 41
Cabling and bus termination for PROFIBUS option boards 42
The OPTE2/OPTE8 Option Boards 42
Exceptions in Connector Pin Outs 42
The Bus Terminal and Bias Resistors 43
Setting the Termination Resistance 44
The OPTC2/C8 and OPTCJ Option Boards 45
Jumpers in the OPTC2/C8, and OPTCJ Option Boards 45
CAN Type and Other Fieldbus Option Boards 48
The OPTE6 and OPTE7 Option Boards 48
The OPTE6 and OPTE7 Option Board Layout 48
The Jumpers in the OPTE6 and OPTE7 Option Boards 48
The OPTC6 Option Board 50
The OPTC6 Option Board Layout 50
The Jumpers in the OPTC6 Option Board 50
The OPTC7 Option Board 51
The OPTC7 Option Board Layout 51
The Jumpers in the OPTC7 Option Board 52
The OPTC4 Option Board 52
The OPTC4 Option Board Layout 52
The Jumpers in the OPTC4 Option Board 53
The OPTC4 Option Board Topologies 53
Troubleshooting 55
LED Indications on PROFIBUS Option Boards 55
LED Indications on OPTE2/E8 Option Boards 56
LED Indications on OPTC2/C8 and OPTCJ Option Boards 57
LED Indications on OPTE6 Option Board 58
LED Indications on OPTC6 Option Board 59
LED Indications on OPTC7 and OPTE7 Option Boards 60
LED Indications on OPTC4 Option Board 61
AN338644703080en-0002/DPD021564 | Danfoss A/S © 2022.08
Contents
VACON® RS485 and CAN Bus Option Boards
Installation Guide
To Next Page
Loading...