Danfoss VACON OPTE3 - Table of Contents

1
1.1
1.2
1.3
1.4
1.4.1
1.4.2
1.4.3
2
2.1
2.2
3
3.1
3.2
3.3
3.4
3.4.1
3.4.2
3.5
4
4.1
4.1.1
4.1.2
4.2
4.3
4.4
4.5
4.6
4.7
5
5.1
5.1.1
5.1.2
5.2
Contents
Introduction 5
Purpose of this Installation Guide 5
Additional Resources 5
Manual Version 5
Product Overview 5
RS485-based Serial Bus Option Boards 5
CAN bus-based and Other Option Boards 6
VACON® 100 Family Internal RS485 Fieldbus Protocols 6
Safety 7
Safety Symbols 7
Safety Instructions 7
Installing 8
Installing Option Board in VACON® NXP and NXS 8
Installing Option Board in VACON® 100 INDUSTRIAL and FLOW 11
Installing Option Board in VACON® 100 X 16
Installing Option Board in VACON® 20 19
Installing Option Board in VACON® 20, MI1–MI3 19
Installing Option Board in VACON® 20, MI4–MI5 25
Installing Option Board in VACON® 20 X and 20 CP 29
Cabling 33
General Cabling Instructions for Fieldbus 33
Cable Routing 33
Strain Relief 34
General Cabling Instructions for RS485 34
Cable Requirements for CAN Type Option Boards 35
Cable Requirements for LON Type Option Boards 36
Fieldbus Connectors 36
Stripping the Cables 37
Grounding the Cable Shield 37
RS485-based Option Boards 39
Common Information for the OPTE3/E5 and OPTE2/E8 Option Boards 39
The OPTE3/E5 and OPTE2/E8 Option Board Layout 39
The Jumpers in the OPTE3/E5 and OPTE2/E8 Option Boards 39
The OPTC3/C5 Option Board 40
AN338644703080en-0002/DPD02156 | 3Danfoss A/S © 2022.08
Contents
VACON® RS485 and CAN Bus Option Boards
Installation Guide