3.6.2 Run with Full Load 18
3.7 AFE Emergency and Restore Procedures
18
3.7.1 Emergency Run when One Slave Unit is Damaged 18
3.7.2 Restoration after Slave Unit is Repaired 19
3.7.3 Emergency Run when Master Unit is Damaged 19
3.7.4 Restoration after Master Unit is Repaired 20
3.7.5 Emergency Run When More Than One Unit is Damaged 20
3.8 Manual Shut Down Sequence
20
3.9 Start-up Sequence
21
3.10 Shut-down Sequence
22
4 How to Install
23
4.1 Overall Typical Frequency Converter Configuration
23
4.2 Pre-installation
24
4.2.1 Planning the Installation Site 24
4.2.2 Receiving the Frequency Converter 24
4.2.3 Transportation and Unpacking 24
4.2.4 Lifting 26
4.2.5 Mechanical Dimensions 27
4.2.6 Weight Information 31
4.3 Mechanical Installation
32
4.3.1 Tools Needed 32
4.3.2 General Considerations 32
4.3.3 Terminal Locations 32
4.3.4 Mains Torque 33
4.3.5 Mains Connection 33
4.3.6 Screened Cables 33
4.4 Electrical Installation
35
4.4.1 Control Wires 36
4.4.2 Power Connections 36
4.4.3 Grounding 36
4.4.4 Electrical Installation, Control Terminals 37
5 Specifications
38
5.1 General Specifications
38
5.2 Mains Supply
42
6 How to Programme
43
6.1 Parameter Selection
43
6.2 Parameters: 0-** Operation and Display
44
6.3 Parameters: 4-** Limits/Warnings
48
Contents Operating Instructions
2 Danfoss A/S © Rev. 05/2014 All rights reserved. MG33X402
To Next Page
Loading...
