5-41 On Delay, Relay
Range: Function:
0.01 s* [0.01 -
600.00 s]
This parameter makes it possible to delay
the cut-in time of the relays. The
selection of each mechanical relay is
realised in an array parameter.
5-42 Off Delay, Relay
Range: Function:
0.01 s* [0.01 -
600.00 s]
This parameter makes it possible to delay
the cut-out time of the relays. The
selection of each mechanical relay is
realised in an array parameter.
How to Programme Operating Instructions
MG33X402 Danfoss A/S © Rev. 05/2014 All rights reserved. 51
6 6
To Next Page
Loading...
