Danfoss vlt aqua Instruction

5.1.4 Changing a text value
If the selected parameter is a text value, it can be changed by using the
up/down navigation keys.
The up key increases the value, and the down key decreases the value.
Place the cursor on the value to be saved and press [OK].
Figure 5.1: Display example.
5.1.5 Changing a group of numeric data values
If the chosen parameter represents a numeric data value, change the
chosen data value by means of the [◄] and [►] navigation keys as well
as the up/down [
▲
] [
▼
] navigation keys. Use the ◄] and [►] navigation
keys to move the cursor horizontally.
Figure 5.2: Display example.
Use the up/down navigation keys to change the data value. The up key
increases the data value, while the down key reduces it. Place the cursor
on the value to be saved and press [OK].
Figure 5.3: Display example.
5.1.6 Changing of data value, Step-by-Step
Certain parameters can be changed step-by-step or by an infinite number of variables. This applies to par. 1-20 Motor Power [kW] , par. 1-22 Motor
Voltage
and par. 1-23 Motor Frequency .
The parameters are changed both as a group of numeric data values, and as numeric data values using an infinite number of variables.
VLT AQUA Low Harmonic Drive Instruction
Manual
5 How to Operate the Low Harmonic Drive
MG.20.T1.22 - VLT
®
is a registered Danfoss trademark 5-7
5

Danfoss vlt aqua Specifications

General

Supply Voltage	200-240V, 380-500V, 525-600V
Enclosure	IP20
Features	Energy optimization
Approvals	CE, UL, cUL
Input Voltage Range	200-240V, 380-500V, 525-600V
Output Voltage Range	0 to supply voltage
Protection Features	Overvoltage, Undervoltage, Overcurrent, Short circuit, Ground fault
Communication Interfaces	PROFIBUS
Cooling Method	Air-cooled