7-07 Speed PID Feedback Gear Ratio
Range: Function:
1.0000* [Application dependant]
7-08 Speed PID Feed Forward Factor
Range: Function:
0 %* [0 - 500 %] The reference signal bypasses the speed controller by the amount specified. This feature increases
the dynamic performance of the speed control loop.
3.9.3 7-1* Torque PI Control
Parameters for configuring the torque PI control in torque open loop (par. 1-00
Configuration Mode
).
7-12 Torque PI Proportional Gain
Range: Function:
100 %* [0 - 500 %] Enter the proportional gain value for the torque controller. Selection of a high value makes the
controller react faster. Too high a setting leads to controller instability.
3 Parameter descriptions FC 300 Programming Guide
130
MG.33.M8.02 - VLT
®
is a registered Danfoss trademark
3
To Next Page
Loading...
