Danfoss VLT AutomationDrive FC 300 Programming Guide

2.1.16 Read-out and Programming of Indexed Parameters
Parameters are indexed when placed in a rolling stack.
Par. 15-30
Fault Log: Error Code to par. 15-32 Alarm Log: Time contain a fault log which can be read out. Choose a parameter, press [OK], and use the
[
▲
] [
▼
] navigation keys to scroll through the value log.
Use par. 3-10
Preset Reference as another example:
Choose the parameter, press [OK], and use the [
▲
] [
▼
] navigation keys to scroll through the indexed values. To change the parameter value, select the
indexed value and press [OK]. Change the value by using the [
▲
] [
▼
] keys. Press [OK] to accept the new setting. Press [CANCEL] to abort. Press [Back]
to leave the parameter.
FC 300 Programming Guide 2 How to Programme
MG.33.M8.02 - VLT
®
is a registered Danfoss trademark 25
2

Danfoss VLT AutomationDrive FC 300 Specifications

General

Brand	Danfoss
Model	VLT AutomationDrive FC 300
Category	DC Drives
Language	English