Danfoss VLT AutomationDrive FC 300 Programming Guide

3 Parameter descriptions
3.1 Parameter Selection
Parameters for FC 300 are grouped into various parameter groups for easy selection of the correct parameters for optimized operation of the frequency
converter.
0-** Operation and Display parameters
• Basic Settings, set-up handling
• Display and Local Control Panel parameters for choosing readouts, setting up selections and copying functions
1-** Load and Motor parameters includes all load and motor related parameters
2-** Brake parameters
•DC brake
• Dynamic brake (Resistor brake)
•Mechanical brake
• Over Voltage Control
3-** References and ramping parameters includes DigiPot function
4-** Limits Warnings; setting of limits and warning parameters
5-** Digital inputs and outputs includes relay controls
6-** Analog inputs and outputs
7-** Controls; Setting parameters for speed and process controls
8-** Communication and option parameters for setting of FC RS485 and FC USB port parameters.
9-** Profibus parameters
10-** DeviceNet and CAN Fieldbus parameters
13-** Smart Logic Control parameters
14-** Special function parameters
15-** Drive information parameters
16-** Readout parameters
17-** Encoder Option parameters
18-** Readout 2 parameters
30-** Special Features
FC 300 Programming Guide 3 Parameter descriptions
MG.33.M8.02 - VLT
®
is a registered Danfoss trademark 29
3

Danfoss VLT AutomationDrive FC 300 Specifications

General

Brand	Danfoss
Model	VLT AutomationDrive FC 300
Category	DC Drives
Language	English