10-31 Store Data Values
Option: Function:
Parameter values changed via DeviceNet are not automatically stored in non-volatile memory. Use
this parameter to activate a function that stores parameter values in the EEPROM non-volatile
memory, so changed parameter values will be retained at power-down.
[0] * Off Deactivates the non-volatile storage function.
[1] Store all setups Stores all parameter values from the active set-up in the non-volatile memory. The selection returns
to Off [0] when all values have been stored.
[2] Store all setups Stores all parameter values for all set-ups in the non-volatile memory. The selection returns to
Off
[0] when all parameter values have been stored.
10-32 Devicenet Revision
Range: Function:
Application
dependent*
[0 - 65535 ] View the DeviceNet revision number. This parameter is used for EDS file creation.
10-33 Store Always
Option: Function:
[0] * Off Deactivates non-volatile storage of data.
[1] On Stores parameter data received via DeviceNet in EEPROM non-volatile memory as default.
10-39 Devicenet F Parameters
Array [1000]
No LCP access
Range: Function:
0 N/A* [0 - 0 N/A] This parameter is used to configure the frequency converter via DeviceNet and build the EDS-file.
3 Parameter descriptions FC 300 Programming Guide
168
MG.33.M8.02 - VLT
®
is a registered Danfoss trademark
3
To Next Page
Loading...
