Danfoss VLT AutomationDrive FC 300 Programming Guide

15-59 CSIV Filename
Range: Function:
Application
dependent*
[0 - 0 ] Shows the currently used CSIV (Costumer Specific Initial Values) filename.
3.16.7 15-6* Option Ident.
This read-only parameter group contains information about the hardware and software configuration of the options installed in slots A, B C0 and C1.
15-60 Option Mounted
Range: Function:
0 N/A* [0 - 0 N/A] View the installed option type.
15-61 Option SW Version
Range: Function:
0 N/A* [0 - 0 N/A] View the installed option software version.
15-62 Option Ordering No
Range: Function:
0 N/A* [0 - 0 N/A] Shows the ordering number for the installed options.
15-63 Option Serial No
Range: Function:
0 N/A* [0 - 0 N/A] View the installed option serial number.
3.16.8 15-9* Parameter Info
15-92 Defined Parameters
Array [1000]
Range: Function:
0 N/A* [0 - 9999 N/A] View a list of all defined parameters in the frequency converter. The list ends with 0.
15-93 Modified Parameters
Array [1000]
Range: Function:
0 N/A* [0 - 9999 N/A] View a list of the parameters that have been changed from their default setting. The list ends with
0. Changes may not be visible until up to 30 seconds after implementation.
15-99 Parameter Metadata
Array [30]
Range: Function:
0* [0 - 9999 ] This parameter contains data used by the MCT10 software tool.
FC 300 Programming Guide 3 Parameter descriptions
MG.33.M8.02 - VLT
®
is a registered Danfoss trademark 211
3

Danfoss VLT AutomationDrive FC 300 Specifications

General

Brand	Danfoss
Model	VLT AutomationDrive FC 300
Category	DC Drives
Language	English