Danfoss VLT AutomationDrive FC 300 Programming Guide

16-11 Power [hp]
Range: Function:
0.00 hp* [0.00 - 10000.00 hp] View the motor power in HP. The value shown is calculated on the basis of the actual motor voltage
and motor current. The value is filtered, and therefore approximately 30 ms may pass from when
an input value changes to when the data read-out values change.
16-12 Motor Voltage
Range: Function:
0.0 V* [0.0 - 6000.0 V] View the motor voltage, a calculated value used for controlling the motor.
16-13 Frequency
Range: Function:
0.0 Hz* [0.0 - 6500.0 Hz] View the motor frequency, without resonance dampening.
16-14 Motor Current
Range: Function:
0.00 A* [0.00 - 10000.00 A] View the motor current measured as a mean value, IRMS. The value is filtered, and thus approxi-
mately 30 ms may pass from when an input value changes to when the data read-out values change.
16-15 Frequency [%]
Range: Function:
0.00 %* [-100.00 - 100.00 %] View a two-byte word reporting the actual motor frequency (without resonance dampening) as a
percentage (scale 0000-4000 Hex) of par. 4-19
Max Output Frequency . Set par. 9-16 PCD Read
Configuration
index 1 to send it with the Status Word instead of the MAV.
16-16 Torque [Nm]
Range: Function:
0.0 Nm* [-3000.0 - 3000.0 Nm] View the torque value with sign, applied to the motor shaft. Linearity is not exact between 160%
motor current and torque in relation to the rated torque. Some motors supply more than 160%
torque. Consequently, the min. value and the max. value will depend on the max. motor current as
well as the motor used. The value is filtered, and thus approx. 30 ms may pass from when an input
changes value to when the data read-out values change.
16-17 Speed [RPM]
Range: Function:
0 RPM* [-30000 - 30000 RPM] View the actual motor RPM. In open loop or closed loop process control the motor RPM is estimated.
In speed closed loop modes the motor RPM is measured.
16-18 Motor Thermal
Range: Function:
0 %* [0 - 100 %] View the calculated thermal load on the motor. The cut-out limit is 100%. The basis for calculation
is the ETR function selected in par. 1-90
Motor Thermal Protection .
16-19 KTY sensor temperature
Range: Function:
0 C* [0 - 0 C] Returning the actual temperature on KTY sensor buil into the motor.
See par. 1-9*.
16-20 Motor Angle
Range: Function:
0* [0 - 65535 ] View the current encoder/resolver angle offset relative to the index position. The value range of
0-65535 corresponds to 0-2*pi (radians).
FC 300 Programming Guide 3 Parameter descriptions
MG.33.M8.02 - VLT
®
is a registered Danfoss trademark 213
3

Danfoss VLT AutomationDrive FC 300 Specifications

General

Brand	Danfoss
Model	VLT AutomationDrive FC 300
Category	DC Drives
Language	English