30-81 Brake Resistor (ohm)
Range: Function:
Application
dependent*
[Application dependant] Set the brake resistor value in Ohms. This value is used for monitoring the power to the brake
resistor in par. 2-13
Brake Power Monitoring
. This parameter is only active in drives with an integral
dynamic brake.
30-83 Speed PID Proportional Gain
Range: Function:
Application
dependent*
[0.0000 - 1.0000 ] Enter the speed controller proportional gain. Quick control is obtained at high amplification. However
if amplification is too great, the process may become unstable.
30-84 Process PID Proportional Gain
Range: Function:
0.100* [0.000 - 10.000 ] Enter the process controller proportional gain. Quick control is obtained at high amplification. How-
ever if amplification is too great, the process may become unstable.
3 Parameter descriptions FC 300 Programming Guide
228
MG.33.M8.02 - VLT
®
is a registered Danfoss trademark
3
To Next Page
Loading...
