Danfoss VLT AutomationDrive FC 361 - Safety; Safety Overview

7 Commissioning
36
7.1 Applying Power
36
7.2 Programming the Drive
36
7.3 Testing Before System Start-up
38
7.4 System Start-up
38
7.5 Parameter Setting
39
8 Wiring Conguration Examples
40
8.1 Introduction
40
8.2 Wiring for Open-loop Speed Control
40
8.3 Wiring for Start/Stop
41
8.4 Wiring for External Alarm Reset
42
8.5 Wiring for a Motor Thermistor
42
9 Maintenance, Diagnostics, and Troubleshooting
43
9.1 Maintenance and Service
43
9.2 Heat Sink Access Panel
43
9.3 Status Messages
44
9.4 Warning and Alarm Types
46
9.5 List of Warnings and Alarms
47
9.6 Troubleshooting
54
10 Specications
57
10.1 Electrical Data, 380-480 V
57
10.2 Mains Supply
58
10.3 Motor Output and Motor Data
59
10.4 Ambient Conditions
59
10.5 Cable Specications
60
10.6 Control Input/Output and Control Data
60
10.7 Fuses and Circuit Breakers
63
10.8 Fastener Tightening Torques
64
10.9 Enclosure Dimensions
65
11 Appendix
71
11.1 Abbreviations and Conventions
71
11.2 Parameter Menu Structure
71
Index
75
Contents VLT® AutomationDrive FC 361
2 Danfoss A/S © 06/2018 All rights reserved. MG06I102