Danfoss VLT AutomationDrive FC 361 - 1 Introduction; Purpose of the Manual; Additional Resources; Manual and Software Version

1 Introduction
1.1 Purpose of the Manual
This operating guide provides information for safe instal-
lation and commissioning of the VLT
®
drives.
The operating guide is intended for use by qualied
personnel. To use the unit safely and professionally, read
and follow this operating guide. Pay particular attention to
the safety instructions and general warnings. Always keep
the operating guide with the drive.
VLT
®
is a registered trademark.
1.2 Additional Resources
Other resources are available to understand advanced
drive functions and programming.
•
The programming guide provides greater detail on
working with parameters and many application
examples.
•
The design guide provides detailed information
about capabilities and functionality to design
motor control systems.
•
Instructions for operation with optional
equipment.
Supplementary publications and manuals are available
from Danfoss. See www.danfoss.com/en/search/?lter=type
%3Adocumentation%2Csegment%3Adds for listings.
1.3
Manual and Software Version
This manual is regularly reviewed and updated. All
suggestions for improvement are welcome. Table 1.1 shows
the version of the manual and the corresponding software
version.
Manual version Remarks Software version
MG06I1xx First edition. 1.0x
Table 1.1 Manual and Software Version
1.4
Approvals and Certications
1.5 Disposal
Do not dispose of equipment containing
electrical components together with
domestic waste.
Collect it separately in accordance with
local and currently valid legislation.
Introduction Operating Guide
MG06I102 Danfoss A/S © 06/2018 All rights reserved. 3
1 1