Danfoss VLT FC 100 Series Programming Guide

2.1.11. Changing a Group of Numeric Data Values
If the chosen parameter represents a numeric data value, change the
chosen data value by means of the [
◀
] [
▶
] navigation keys as well as
the [
▲
] [
▼
] navigation keys. Use the [
◀
] [
▶
] navigation keys to move
the cursor horizontally.
130BP069.10
Use the [
▲
] [
▼
] navigation keys to change the data value. The up key
enlarges the data value, and the down key reduces the data value. Place
the cursor on the value you want to save and press [OK].
130BP070.10
2.1.12. Changing a Data Value,Step-by-Step
Certain parameters can be changed step by step or infinitely varying. This applies to Motor Power (par. 1-20), Motor Voltage (par. 1-22) and Motor
Frequency
(par. 1-23).
The parameters are changed both as a group of numeric data values and as numeric data values infinitely varying.
2.1.13. Read-out and Programming of Indexed Parameters
Parameters are indexed when placed in a rolling stack.
Par. 15-30 to 15-33 contain a fault log which can be read out. Choose a parameter, press [OK], and use the up/down navigation keys to scroll through
the value log.
Use par. 3-10 as another example:
Choose the parameter, press [OK], and use the up/down navigation keys keys to scroll through the indexed values. To change the parameter value,
select the indexed value and press [OK]. Change the value by using the up/down keys. Press [OK] to accept the new setting. Press [CANCEL] to abort.
Press [Back] to leave the parameter.
VLT
®
HVAC Drive Programming Guide 2. How to Programme
MG.11.C5.02 - VLT
®
is a registered Danfoss trademark 21
2

Danfoss VLT FC 100 Series Specifications

General

Brand	Danfoss
Model	VLT FC 100 Series
Category	DC Drives
Language	English