0-72 Time Format
Option: Function:
Sets the time format to be used in the LCP.
[0]
*
24 H
[1] 12 H
0-73 Time Zone Offset
Range: Function:
0.00
*
[ -12.00 - 13.00]
Sets the time zone offset to UTC, this is needed for automatic DST adjustment.
0-74 DST/Summertime
Option: Function:
Choose how Daylight Saving Time/Summertime should be handled. For manual DST/Summertime enter the start
date and end date in par. 0-76 and par. 0-77.
[0]
*
OFF
[2] Manual
0-76 DST/Summertime Start
Range: Function:
2000-01-01 00:00
*
[2000-01-01
00:00 – 2099-12-31 23:59 ]
Sets the date and time when summertime/DST starts. The date is programmed in the format selected in par.
0-71.
0-77 DST/Summertime End
Range: Function:
2000-01-01 00:00
*
[2000-01-01
00:00 – 2099-12-31 23:59 ]
Sets the date and time when summertime/DST ends. The date is programmed in the format selected in par.
0-71.
0-79 Clock Fault
Option: Function:
Enables or disables the clock warning, when the clock has not been set or has been reset due to a power-down
and no backup is installed.
[0]
*
Disabled
[1] Enabled
0-81 Working Days
Array with 7 elements [0]-[6] displayed below parameter number in display. Press OK and Step between elements by means of
▲
and
▼
buttons on the
LCP.
Set for each weekday if it is a working day or a non-working day. First element of the array is Monday. The
working days are used for Timed Actions.
[0] No
[1]
*
Yes
0-82 Additional Working Days
Array with 5 elements [0]-[4] displayed below parameter number in display. Press OK and Step between elements by means of
▲
and
▼
buttons on the
LCP.
VLT
®
HVAC Drive Programming Guide 3. Parameter Description
MG.11.C5.02 - VLT
®
is a registered Danfoss trademark
37
3
To Next Page
Loading...
