Danfoss VLT Flow Drive FC 111 - Page 146

Bit
Bit=0
Bit=1
07
No warning
Warning
08
Speed ≠ ref.
Speed = ref.
09
Local control
Bus control
10
Out of range
Frequency OK
11
Not running
Running
12
No function
No function
13
Voltage OK
Above limit
14
Current OK
Above limit
15
Thermal-level OK
Above limit
Table 299: Range:
Min: 0
Max: 65535
Default value: 0
16-05 Main Actual Value [%]
Default value: 0%
Parameter type: Range
2-setup: 1 setup
Conversion index: -2
Data type: int16
Change during operation: True
View the 2 byte word sent with the status word to the bus master reporting the main actual value.
Table 300: Range:
Min: -200%
Max: 200%
Default value: 0%
16-09 Custom Readout
Default value: 0 CustomReadoutUnit
Parameter type: Range
2-setup: 1 setup
Conversion index: -2
Data type: int32
Change during operation: True
View the user-defined readouts as defined in parameter 0-30 Custom Readout Unit, parameter 0-31 Custom Readout Min Value, and
parameter 0-32 Custom Readout Max Value.
Table 301: Range:
Min: 0
Max: 9999 CustomReadoutUnit
Default value: 0 CustomReadoutUnit
4.13.2 16-1* Motor Status
Parameters for reading the motor status values.
16-10 Power [kW]
Default value: 0 kW
Parameter type: Range
2-setup: 1 setup
Conversion index: -3
Data type: u_int32
Change during operation: True
Display the actual motor power in kW. The value shown is calculated on the basis of the actual DC-link voltage and DC-link current.
Table 302: Range:
Min: 0 kW
Max: 1000 kW
Default value: 0 kW
AU363928304090en-000101 / 130R0982146 | Danfoss A/S © 2021.07
Parameters
VLT® Flow Drive FC 111
Programming Guide