Danfoss VLT Micro Drive FC 51 Series - Load;Motor Parameters (1-**)

To Next Page

To Previous Page

Parameter Number Parameter Description Default Value 2 Setup Change During Operation Conversion Index Type

0 - 03 Regional Settings [0] International 1 set-up FALSE - Uint8

0 - 04 Operating State at Power-up (Hand) [1] Forced stop ref=old All set-ups TRUE - Uint8

0 - 10 Active Set-up [1] Set-up 1 1 set-up TRUE - Uint8

0 - 11 Edit Set-up [1] Set-up 1 1 set-up TRUE - Uint8

0 - 12 Link Setups [20] Linked All set-ups FALSE - Uint8

0 - 40 [Hand on] Key on LCP [1] Enabled All set-ups TRUE - Uint8

0 - 41 [Off / Reset] Key on LCP [1] Enable All All set-ups TRUE - Uint8

0 - 42 [Auto on] Key on LCP [1] Enabled All set-ups TRUE - Uint8

0 - 50 LCP Copy [0] No copy 1 set-up FALSE - Uint8

0 - 51 Set-up Copy [0] No copy 1 set-up FALSE - Uint8

0 - 60 Main Menu Password 0 1 set-up TRUE 0 Uint16

6.2.5 0-** Operation/Display

6 Parameter Overview VLT

Micro Drive FC 51 Operating Instructions

MG.02.A4.02 - VLT

is a registered Danfoss trademark

Other manuals for Danfoss VLT Micro Drive FC 51 Series