Danfoss VLT Micro Drive FC 51 Series - Before Commencing Repair Work

1.1.7 Disposal instruction
Equipment containing electrical components must not be disposed of together with domestic waste.
It must be separately collected with electrical and electronic waste according to local and currently valid leg-
islation.
1.1.8 Before Commencing Repair Work
1. Disconnect FC 51 from mains (and external DC supply, if present.)
2. Wait for 4 minutes for discharge of the DC-link.
3. Disconnect DC bus terminals and brake terminals (if present)
4. Remove motor cable
1 Safety VLT
®
Micro Drive FC 51 Operating Instructions
8 MG.02.A4.02 - VLT
®
is a registered Danfoss trademark
1