Danfoss VLT Micro Drive FC 51 Series - Analog In;Out Parameters (6-**)

To Next Page

To Previous Page

Parameter Number Parameter Description Default Value 2 Setup Change During Operation Conversion Index Type

5 - 10 Terminal 18 Digital Input [8] Start All set-ups TRUE - Uint8

5 - 11 Terminal 19 Digital Input [10] Reversing All set-ups TRUE - Uint8

5 - 12 Terminal 27 Digital Input [1] Reset All set-ups TRUE - Uint8

5 - 13 Terminal 29 Digital Input [14] Jog All set-ups TRUE - Uint8

5 - 15 Terminal 33 Digital Input [16] Preset ref bit 0 All set-ups TRUE - Uint8

5 - 40 Function Relay [0] No operation All set-ups TRUE - Uint8

5 - 55 Terminal 33 Low Frequency 20 Hz All set-ups TRUE 0 Uint16

5 - 56 Terminal 33 High Frequency 5000 Hz All set-ups TRUE 0 Uint16

5 - 57 Terminal 33 Low Ref./Feedb. Value 0 All set-ups TRUE -3 Int32

5 - 58 Terminal 33 High Ref./Feedb. Value 50 All set-ups TRUE -3 Int32

6.2.10 5-** Digital In/Out

VLT

Micro Drive FC 51 Operating Instructions 6 Parameter Overview

MG.02.A4.02 - VLT

is a registered Danfoss trademark

Other manuals for Danfoss VLT Micro Drive FC 51 Series