Danfoss VLT Micro Drive FC 51 Series - Reference;Ramps Parameters (3-**)

To Next Page

To Previous Page

Parameter Number Parameter Description Default Value 2 Setup Change During Operation Conversion Index Type

2 - 00 DC Hold Current 50% All set-ups TRUE 0 Uint16

2 - 01 DC Brake Current 50% All set-ups TRUE 0 Uint16

2 - 02 DC Braking Time 10 s All set-ups TRUE -1 Uint16

2 - 04 DC Brake Cut In Speed 0 Hz All set-ups TRUE -1 Uint16

2 - 10 Brake Function [0] Off All set-ups TRUE - Uint8

2 - 11 Brake Resistor (ohm) All set-ups TRUE 0 Uint16

2 - 16 AC Brake, Max current 100% All set-ups TRUE 0 Uint16

2 - 17 Over-voltage Control [0] Disabled All set-ups TRUE - Uint8

2 - 20 Release Brake Current 0 A All set-ups TRUE -2 Uint32

2 - 22 Activate Brake Speed [Hz] 0 Hz All set-ups TRUE -1 Uint16

6.2.7 2-** Brakes

6 Parameter Overview VLT

Micro Drive FC 51 Operating Instructions

MG.02.A4.02 - VLT

is a registered Danfoss trademark

Other manuals for Danfoss VLT Micro Drive FC 51 Series