Danfoss VLT Micro Drive FC 51 Series - Modbus RTU; Modbus RTU Overview

7-38 Process Feed Forward Factor
Range: Function:
[0 - 400%] Only applicable with changing set-points.
4.5 Main Menu
The Main Menu gives access to all parameters.
1. To enter the Main Menu, press [MENU] key until indicator in
display is placed above
Main Menu .
2.
Use [
▲
] [
▼
] to browse through the parameter groups.
3. Press [OK] to select a parameter group.
4.
Use [
▲
] [
▼
] to browse through the parameters in the specific
group.
5. Press [OK] to select the parameter.
6.
Use [
▲
] [
▼
] to set/change the parameter value.
7. Press [OK] to accept the value.
8. To exit, press either [Back] twice to enter
Quick Menu , or press
[Menu] once to enter
Status .
Illustration 4.10: Indicating Main Menu mode
4 Programming VLT
®
Micro Drive FC 51 Operating Instructions
24 MG.02.A4.02 - VLT
®
is a registered Danfoss trademark
4