Danfoss VLT Design Guide

Set Action 4 in 13-52 SL Controller Action [4] to No Action
[1]
Illustration 6.6
Set the Smart Logic Control in 13-00 SL Controller Mode to
ON.
Start/stop command is applied on terminal 18. If stop
signal is applied the frequency converter will ramp down
and go into free mode.
Application Examples
VLT
®
Refrigeration Drive Design Guide
MG16G102 - VLT
®
is a registered Danfoss trademark 85
6
6

Danfoss VLT Specifications

General

Frequency	50/60 Hz
Enclosure	IP20, IP21, IP55, IP66
Series	VLT
Control Technique	Flux Vector Control
Output Voltage	0-Vinput
Control Method	Fieldbus
Communication Interface	PROFIBUS, CANopen
Protection Features	Overload, Overvoltage, Undervoltage, Short Circuit, Ground Fault
Cooling Method	Liquid Cooled
Storage Temperature	-25°C to +70°C
Relative Humidity	5-95% non-condensing
Altitude	Up to 1000m (3280ft) without derating, up to 4000m (13120ft) with derating
Operating Temperature	-10°C to +50°C (14°F to 122°F)