Danfoss VLT Design Guide

7.3.6 The Data Field
The structure of data blocks depends on the type of
telegram. There are three telegram types, and the type
applies for both control telegrams (master=>slave) and
response telegrams (slave=>master).
The 3 types of telegram are:
Process block (PCD)
The PCD is made up of a data block of 4 bytes (2 words)
and contains:
- Control word and reference value (from master to
slave)
- Status word and present output frequency (from
slave to master)
Illustration 7.7
Parameter block
The parameter block is used to transfer parameters
between master and slave. The data block is made up of
12 bytes (6 words) and also contains the process block.
Illustration 7.8
Text block
The text block is used to read or write texts via the data
block.
Illustration 7.9
7.3.7 The PKE Field
The PKE field contains two sub-fields: Parameter command
and response AK, and Parameter number PNU:
Illustration 7.10
RS-485 Installation and Set...
VLT
®
Refrigeration Drive Design Guide
MG16G102 - VLT
®
is a registered Danfoss trademark 89
7
7

Danfoss VLT Specifications

General

Frequency	50/60 Hz
Enclosure	IP20, IP21, IP55, IP66
Series	VLT
Control Technique	Flux Vector Control
Output Voltage	0-Vinput
Control Method	Fieldbus
Communication Interface	PROFIBUS, CANopen
Protection Features	Overload, Overvoltage, Undervoltage, Short Circuit, Ground Fault
Cooling Method	Liquid Cooled
Storage Temperature	-25°C to +70°C
Relative Humidity	5-95% non-condensing
Altitude	Up to 1000m (3280ft) without derating, up to 4000m (13120ft) with derating
Operating Temperature	-10°C to +50°C (14°F to 122°F)